Skip to Content
Merck
CN
  • Simultaneous determination of volatile organic compounds with a wide range of polarities in urine by headspace solid-phase microextraction coupled to gas chromatography/mass spectrometry.

Simultaneous determination of volatile organic compounds with a wide range of polarities in urine by headspace solid-phase microextraction coupled to gas chromatography/mass spectrometry.

Rapid communications in mass spectrometry : RCM (2017-01-14)
Han-Na Song, Chong Hyeak Kim, Won-Yong Lee, Sung-Hee Cho
ABSTRACT

Volatile organic compounds (VOCs) are ubiquitous environmental pollutants that have a high vapor pressure at room temperature. Some VOCs have been classified as carcinogenic to humans by the International Agency for Research on Cancer (IARC), because they can bind to DNA and cause cell mutations. Therefore, monitoring of VOCs in human urine is very important to evaluate the correlation between exposure to VOCs and human disease. We have developed an improved analytical method for the simultaneous determination of VOCs with a wide range of polarities in human urine samples by headspace solid-phase microextraction (HS-SPME) coupled to gas chromatography/mass spectrometry (GC/MS). In the improved method, a bi-polar carboxen-polydimethylsiloxane (CAR/PDMS) fiber was used for the optimized extraction of 15 VOCs with a wide range of polarities, including benzene, toluene, ethylbenzene, xylenes (BTEX), alkylbenzenes, cresols, and naphthalene, in human urine samples. Extracted VOCs from the human urine were effectively separated by GC using a mid-polarity column (DB-35, 35% phenylmethylpolysiloxane) and monitored by MS using extracted ion monitoring (EIM) mode. Under the optimized method, the linearity of the calibration curves was greater than 0.993. The limits of detection (LODs) at a signal-to-noise (S/N) ratio of 3 were 0.3-0.6 ng/mL. The coefficients of variation were in the range of 0.1-9.7% for within-day variation and 0.2-14.2% for day-to-day variation. The method was shown to be rapid and simple for the simultaneous determination of VOCs with a wide range of polarities in human urine and it could be applied to monitoring and to biomedical investigations to check exposure to VOCs. Copyright © 2017 John Wiley & Sons, Ltd.

MATERIALS
Product Number
Brand
Product Description

Supelco
SPME Portable Field Sampler, coating CAR/PDMS
Supelco
SPME Fiber Assembly, 7 μm PDMS, Fused Silica (1 cm), needle size 23 ga, Autosampler, pk of 3, green hub
Supelco
SPME Sampling Stand, for use with 15 mL vials
Supelco
Carboxen® Adsorbent, matrix Carboxen® 564, 20-45 mesh, pack of 144 × 290 mg
Supelco
SPME Fiber Assembly, 65 μm PDMS/DVB, Fused Silica (1 cm), needle size 23 ga, Manual Holder, pk of 3, blue hub
Supelco
SPME Portable Field Sampler, coating PDMS/DVB
Supelco
SPME Fiber Assembly, 75 μm CAR/PDMS, Fused Silica (1 cm), needle size 24 ga, Autosampler, pk of 3, black hub
Supelco
SPME Fiber Assembly, 30 μm PDMS, Fused Silica (1 cm), needle size 24 ga, Manual Holder, pk of 3, yellow hub
Supelco
SPME Fiber Assembly, 85 μm Polyacrylate, Fused Silica (1 cm), needle size 24 ga, Manual Holder, pk of 3, white hub
Supelco
SPME Fiber Assembly, 30 μm PDMS, Fused Silica (1 cm), needle size 24 ga, Autosampler, pk of 3, yellow hub
Supelco
SPME Fiber Assembly, 100 μm PDMS, Fused Silica (1 cm), needle size 24 ga, Autosampler, pk of 3, red hub
Supelco
Carboxen® Adsorbent, matrix Carboxen® 1000, 40-60 mesh, bottle of 50 g
Supelco
SPME Fiber Assembly, 7 μm PDMS, Fused Silica (1 cm), needle size 24 ga, Manual Holder, pk of 3, green hub
Supelco
SPME Fiber Assembly, 7 μm PDMS, Fused Silica (1 cm), needle size 24 ga, Autosampler, pk of 3, green hub
Supelco
SPME Fiber Assembly, 100 μm PDMS, Fused Silica (1 cm), needle size 23 ga, Manual Holder, pk of 3, red hub
Supelco
Carboxen® Adsorbent, matrix Carboxen® 569, 20-45 mesh, bottle of 10 g
Supelco
Carboxen® Adsorbent, matrix Carboxen® 1000, 60-80 mesh, bottle of 10 g
Supelco
Carboxen®-1006 PLOT Capillary GC Column, L × I.D. 30 m × 0.53 mm, average thickness 30 μm
Supelco
Carboxen®-1010 PLOT Capillary GC Column, L × I.D. 30 m × 0.32 mm, average thickness 15 μm
Supelco
Carboxen® Adsorbent, matrix Carboxen® 1003, 40-60 mesh, bottle of 10 g
Supelco
Carboxen®-1010 PLOT Capillary GC Column, L × I.D. 30 m × 0.53 mm, average thickness 30 μm
Supelco
SPME Portable Field Sampler, coating PDMS
Supelco
SPME Fiber Assembly, 85 μm Polyacrylate, Fused Silica (1 cm), needle size 24 ga, Autosampler, pk of 3, white hub
Supelco
SPME Fiber Assembly, 65 μm PDMS/DVB, Fused Silica (1 cm), needle size 24 ga, Autosampler, pk of 3, blue hub
Supelco
SPME Fiber Assembly, 75 μm CAR/PDMS, Fused Silica (1 cm), needle size 24 ga, Manual Holder, pk of 3, black hub
Supelco
SPME Fiber Assembly, 50/30µm DVB/CAR/PDMS, Metal Alloy (1cm), needle size 23 ga, Autosampler, pk of, plain gray hub
Supelco
SPME Fiber Assembly, 60 μm PEG, Metal Alloy (1 cm), needle size 23 ga, Manual Holder, pk of 3, purple hub
Supelco
SPME Fiber Assembly, 100 μm PDMS, Metal Alloy (1 cm), needle size 23 ga, Autosampler, pk of 1, red hub
Supelco
Carboxen® 1000 Reversible SPE Tube, 200 mg/mL, pk 30
Supelco
Carboxen® Adsorbent, matrix Carboxen® 569, 20-45 mesh, bottle of 500 g