表单
liquid
制造商/商品名称
Calbiochem®
储存条件
OK to freeze
protect from light
运输
wet ice
储存温度
2-8°C
一般描述
A single component reagent for chemiluminescent detection of immobilized proteins, labeled with horseradish peroxidase, by immunoblotting. Provides a bright, stable signal with low signal:background. Does not require mixing of substrate and enhancer solutions. Volume is sufficient for covering up to 2000 cm2 of membrane.
A single component reagent for chemiluminescent detection of immobilized proteins, labeled with horseradish peroxidase, by immunoblotting. Volume supplied is sufficient for covering up to 2000 cm2 of membrane.
RapidStep ECL is a 1 STEP chemiluminescent substrate reagent for detection of horseradish peroxidase (HRP) on immunoblots. It is a convenient, cost-effective, and ready-to-use reagent that provides a superior, longer-lasting signal than traditional ECL reagents.
RapidStep contains luminol and enhancer combined in one solution and is ready-to-use without mixing. A spray bottle is used to apply the solution directly onto the membrane.
RapidStep contains luminol and enhancer combined in one solution and is ready-to-use without mixing. A spray bottle is used to apply the solution directly onto the membrane.
This RapidStep ECL Reagent is validated for use in Immunoblotting for the detection of RapidStep ECL Reagent.
应用
Immunoblotting
其他说明
To achieve an optimal signal:noise ratio, it is necessary to optimize the concentration of primary and secondary antibodies.
Protocol for Use
1. Remove the membrane containing immobilized proteins from the last wash and place on a flat surface, protein side facing up. Do not allow the membrane to dry
2. Spray RapidStep ECL Reagent on the surface of the membrane to sufficiently cover the entire membrane. Gently shake the container to ensure the membrane is evenly covered. Generally 2 sprays are sufficient to cover a 5 cm x 5 cm area.
3. Incubate the membrane for 1 min at room temperature without agitation. Proteins with low specificity or low reactivity with the primary antibody may require longer incubation times.
4. Drain the excess RapidStep ECL Reagent by holding the membrane vertically and touch the edge of the membrane against absorbent paper. Failure to drain sufficiently may lead to high background.
5. Wrap the membrane in plastic wrap and gently smooth out air pockets.
6. Place the membrane in a film cassette, protein side facing up.
7. Place X-ray film on top of the membrane, close the cassette and expose for an appropriate period of time. Optimal exposure times should be determined for each experiment.
Protocol for Use
1. Remove the membrane containing immobilized proteins from the last wash and place on a flat surface, protein side facing up. Do not allow the membrane to dry
2. Spray RapidStep ECL Reagent on the surface of the membrane to sufficiently cover the entire membrane. Gently shake the container to ensure the membrane is evenly covered. Generally 2 sprays are sufficient to cover a 5 cm x 5 cm area.
3. Incubate the membrane for 1 min at room temperature without agitation. Proteins with low specificity or low reactivity with the primary antibody may require longer incubation times.
4. Drain the excess RapidStep ECL Reagent by holding the membrane vertically and touch the edge of the membrane against absorbent paper. Failure to drain sufficiently may lead to high background.
5. Wrap the membrane in plastic wrap and gently smooth out air pockets.
6. Place the membrane in a film cassette, protein side facing up.
7. Place X-ray film on top of the membrane, close the cassette and expose for an appropriate period of time. Optimal exposure times should be determined for each experiment.
法律信息
CALBIOCHEM is a registered trademark of Merck KGaA, Darmstadt, Germany
免责声明
Toxicity: Irritant (B)
储存分类代码
12 - Non Combustible Liquids
WGK
WGK 1
闪点(°F)
Not applicable
闪点(°C)
Not applicable
我们的科学家团队拥有各种研究领域经验，包括生命科学、材料科学、化学合成、色谱、分析及许多其他领域.
联系客户支持