iON^™ 尼龙/ABS合金3D打印细丝

iOn^™ Nylon/ABS Alloy is an engineering grade material that can be used in demanding applications where PLA and ABS fail due to shortcomings in mechancial; thermal; or chemical performance. 
Select iOn^™ Nylon/ABS Alloy when you want to create parts that focus on functionality; not just fit and finish. 
Manufactured in the USA from virgin resins selected specifically for 3D Printing.
We use state-of-the-art resins; colorants; manufacturing technologies to give you the best possible printing experience. 

Product Attributes:

• True Alloy (not a blend); single Tg
• Higher Thermal Resistance vs. ABS
• Superior Impact Strength vs. ABS
• Improved Solvent Resistance vs. ABS
• Low-Gloss Surface
• Excellent Fatigue Resistance
• Lower Friction/Wear
• Paintable Surface
• Excellent Printability   
• Chemical Resistance: iOn Nylon/ABS Alloy has improved chemical resistance vs. ABS.  This creates wider opportunities for prototyping demanding applications in a number of industries.

Recommended Print Conditions:

• Suitable for use on practically ANY desktop 3D Printer; including Makerbot Replicator; Makergear; Ultimaker; Prinrbot; Reprap; Mendel; Prusa; Up! Printers; Solidoodle as well as any printer that has a heated bed.
• Extruder: 245 - 260 °C (ideal layer bonding at 250 - 260 °C); or hotter if you have an all-metal hot-end.  However; do not exceed 300 °C to avoid the onset of polymer degradation.  
• Bed Temp: 105 -110 °C
• Bed Prep: Ideally use Polyimide Tape & ABS/Acetone Slurry [together] or any surface you′ve been using with nylon-based filaments. Please note that acetone has difficulty dissolving iON^™ and standard ABS should be used to make the slurry.  
• Drying: iON^™ is an alloy of Nylon and ABS and therefore absorbs more moisture than ABS would normally alone.  If the filament is stored in humid environments for an extended period of time - it will absorb moisture.  While not in use; we recommend storing iON^™ in the Mylar pouch that comes with the filament.  However; if drying is needed (you hear popping noises during printing - generally water boiling off from the resin); then we recommend drying in an oven at 175 °F (F; not C) for 2-4 hours.  

iON^™ is a trademark of 3DXTech^™
Product of 3DXTech^™

3DXTech is a trademark of 3DXTech

iOn is a trademark of 3DXTech