The effect of polysorbate 20 on solubility and stability of candesartan cilexetil in dissolution media.

The addition of polysorbate 20 (T20) is required to achieve "sink" conditions during a dissolution test for tablets with candesartan cilexetil (CC). Polysorbate 20 (0.35%-0.7% w/w) added to 0.05 mol/L of phosphate buffer pH 6.5 dramatically increased the apparent solubility of the drug from 0.8 μg/ml even to 353 μg/ml, while its effect in lower pH or in water was much smaller (20 μg/ml in pH 4.5). The increased concentration of phosphate salts (0.2 mol/l) at pH 6.5 in the presence of 0.7% of polysorbate 20, resulted in further increase of candesartan cilexetil solubility to 620 μg/ml. The change of pH from 1.2 to 7.4 resulted in a 1.5-fold increase of the activation energy and, depending on temperature, 8-14-fold decrease of the degradation rate. When polysorbate 20 increased the activation energy 2-fold, independent of pH, it protected candesartan cilexetil from degradation; however, this effect was temperature dependent and was very small at 310 K-the degradation rate in pH 6.5 decreased by 13% only. It was calculated that in the phosphate buffer pH 6.5 with polysorbate, one can expect during 24 h the degradation at the level of 9.3%, thus a flow-through dissolution apparatus was recommended for testing prolonged release dosage forms.